Sanko MARM1120W 4-Axis Monitor Arm Pole Mount

4-Axis Monitor Arm Mount - Holds up to 11.0 lbs (5 kg) of load capacity with a sturdy clip-type monitor arm. Many customers often use pole racks as desks for putting their computers, but the normal monitor arms are installed between the surface of the desk, so they could not be used if they wanted to install the arm. The 4-Axis Monitor Arm Mount is a monitor arm that can be mounted between 0.6 - 1.2 inches (15 - 30 mm) poles, so it can be used in a variety of locations. In addition, this monitor arm allows you to use your desk as well as easily moving it back when you don't need it, so why not try using it once? Introduction Arm Movement Moves front and back arms 4-Axis Clip Arm Up to 475mm from clipped pole. Moves front and back of arms 4-axis clip-on arm. If you extend to about 18.5 inches (469 mm) from the clipped pole and lower the monitor to the back with the front facing the monitor, the arms are folded together and down to 3.9 inches (100 mm) from the pole. Left and right arm movement The 1 axis close to the pole is about 360°, and the 2 axis moves 360° left and right. Approximately 360° from the first axis close to the pole. The second axis is is a multi-stage arm, so it can be swied from side to side to side by about 360°. Movement above and below arm Just tighten with the included hex wrench. You can set the arm to any height you want. The arm that can be attached to a pole or metal rack is easily secured by simply tightening the two screws with the included hex wrench. You can place your monitor at any height or position you want. The range of motion up and down may vary depending on the circumstances such as the size of the monitor and where the metal rack is placed. Monitor Movement Monitor up/down, left/right, and rotating motion Monitor up/down approx. 180°, left and right, 180°, rotation movement 360°. The monitor part can be moved up and down to about 180°. When it comes to rotation, it can be rotated 360°. Installation Clip on Clip attachment details The clip part has a rubber sheet that can be clipped to metal racks, poles, etc. for worry-free installation. In addition, by tightening with two screws, it can achieve a load capacity of 11.0 lbs (5 kg). The clip pole can be made from 0.6 inch (15 mm) to 1.2 inch (30 mm). Monitor part Rear LCD monitor, VESA standard. Hardware that holds the monitor in place can be easily removed Many LCD monitors have made the mounting dimensions of the arms and stands to 75mm x 75mm and 100mm x 100mm. This standard is called VESA standard. Our monitor arms are compatible with all models and VESA standards. Cable Wiring Clip Get in the way on a sagging desk

• Weight: 4.4 lbs (2
• Load Capacity: 11.0 lbs (5 kg)
• Compatible Monitors with VESA standards (75mm x 75mm or 100mm x 100mm)
• Compatible Pole Width: 0.6 - 1.2 inches (15 - 30 mm)